![]() ![]() To clarify, in my original post I was actually just comparing the Redarc SBI12 isolator, not their DC to DC charger, to the Blue Sea. ![]() Silver contacts for longer life and suitable for marine applications The Redarc can sense the aux battery and optimize the charge for it.The Smart Start SBI battery isolator is a safe way to top-up your secondary battery in your dual battery system with its power saving technology for the ultimate performance. Its low standby current draw and sophisticated fault detection and LED indication of operation warns the user of faults including over-voltage, voltage drop, and excessive current draw conditions. Description The REDARC Smart Start SBI212D is a microprocessor-controlled dual battery isolator used in a dual battery system. It is better than a diode battery isolator due to the voltage drop associated with diode type isolation. ![]() It incorporates electronic components to prevent the solenoid from generating high voltage transients. It’s primarily used in commercial vehicle dual battery systems. ![]() The SBI212 is designed for extremely heavy-duty operations. It provides 12-volt DC with the incorporation of 200A of continuous ratings. Installation of REDARC smart battery isolators should also see the use of quality fuse kits.The REDARC Smart Start SBI212 is a battery isolator used as a solenoid priority system to protect the start battery from excessive discharge while the auxiliary battery is supplying non-essential loads. Not to mention, they have a sophisticated fault detection system which can warn you of over-voltage, voltage drops and excessive draw conditions. The easy-to-install kit is suited for the everyday DIYer since the SBI12KIT doesnt require any crimping or soldering. With state of the art power saving technology, our dual battery isolator kits are compact in size and easy to install. REDARC SMART START BATTERY ISOLATOR & WIRING KIT 12V. Silver contacts for longer life and suitable for marine applications As a microprocessor-controlled battery isolator, the REDARC Smart Start SBI range protects your primary battery by using your alternator to charge your auxiliary battery.Isolator switches off to prevent dead battery if start battery voltage drops too low. The SBI12-BLD smart start battery isolator incorporates a number of spike protection components specifically designed to reduce the risk of damaging the unit, and is designed to prevent any spikes generated by the solenoid coil from affecting vehicle equipment. Redarc the leaders in research, design, development & manufacture of electronic voltage converters, inverters, power supplies, battery chargers & more. Redarc This 100-amp dual-battery isolator pulls power from your start battery to charge your auxiliary battery. It is designed to protect the start battery from. Similarly, if the battery climbs back above a suitable level, the Load Disconnect Isolator will restore power to the connected loads. The REDARC Smart Start SBI212D is a 12v 200A dual battery isolator used in a dual battery system. Charge your auxiliary battery whilst driving. It protects the start battery from excessive discharge while allowing the auxiliary battery to supply non-essential loads. Put simply, once the auxiliary battery has been overly discharged, the Load Disconnect Isolator will turn off any connected loads. The REDARC Smart Start SBI212D is a microprocessor controlled dual battery isolator used in a dual battery system. The REDARC Smart Start SBI12D is a 100A 12v dual battery isolator used in a dual battery system. Falling below this threshold would prevent many chargers from recharging the battery. The Redarc Smart Start® is a microprocessor-controlled battery isolator designed for use in multi-battery applications as a solenoid priority system, protecting the start battery from excessive discharge, whilst allowing the auxiliary battery to supply non-essential loads. The SBI12-LLD is designed for use in lithium battery applications (LiFePO4) as a system to protect the battery from being excessively discharged by auxiliary loads, enabling the auxiliary battery to remain above the level at which internal protection circuitry would activate. The SBI12-LLD is a microprocessor-controlled Load Disconnect Isolator. The REDARC Smart Start is Australias most trusted dual battery isolator and is used by 4WD clubs throughout the country. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |